X5 LoRa Radio

Make your X5 Receiver Module compatible with Trimble SPS855, Emlid RS2 and other GNSS Base Stations through LoRa communications.

The X5 LoRa radio is an adapter system for your X5 Receiver to get GNSS corrections for any GNSS Base Station that uses this protocol. The LoRa radio parameters of this device are fixed on certain values, therefore the Metta X5 Receiver (ROVER) should have the same parameters to receive the corrections correctly.

METTATEC

San Borja, PE

View profile

Description

Main advantages

No need to open or modify your Base station
Lightweight microelectronics: 80 grams
Easy to transport and set up in remote locations

How to connect the X5

The LoRa radio parameters of this device are fixed on certain values, therefore the Metta X5 Receiver (ROVER) should have the same parameters to receive the corrections
correctly.

The Metta X5 Receiver should be in configuration mode.
Connect your phone/tablet with the device through Wi-Fi using SSID and password.
Open the “FindX5” app (only Android supported)
The app will display this message if the phone is not connected to the Metta X5 device.
Otherwise, if the phone is connected to the device Wi-Fi, it will lead you to the main page of the web app where you can configure your Metta X5 device.
Go to the System Configuration section, make sure the “Enable PPK mode” is disabled. Select the following parameters for the LoRa communication.
Click the Save button in order to save all the modifications.
Click the Exit button to return to the operating mode after saving the configuration.