GNSS RTK Base station Geometer
GNSS RTK base station based on dual-frequency GM SMART L1/L2 receiver. The base station can be used as a receiver and transmitter that transmits satellite corrections to any RTK rover. The presence of two frequencies L1 and L2 provides a high level of accuracy and initialization time - the time required by the receiver to obtain a solution when working in RTK mode.
Description
GNSS RTK base station based on dual-frequency GM SMART L1/L2 receiver.
The base station can be used as a receiver and transmitter that transmits satellite corrections to any RTK rover. The presence of two frequencies L1 and L2 provides a high level of accuracy and initialization time - the time required by the receiver to obtain a solution when working in RTK mode. This will allow you to focus completely on your work, as you can always be sure of the reliability of the equipment.
The base station can be set up as static, with reference coordinates at the installation point, and can also be used as a mobile base station with automatic calibration of position. It has a built-in battery for stand-alone or backup power and can run for up to 30 hours on batteries at a temperature of +22 degrees.
The base station can be integrated into an RTK network with the transmission of a correction signal with a radius of 50 km or more, with the creation of a network solution NEAREST. The positioning accuracy of the network solution is considered to be about 2.5 cm. If you work with a direct connection to the base station, the error varies at the rate of 1 mm per 1 km of distance from the base station of the rover receiver.
An unlimited number of rovers can be connected to the GNSS RTK base station.
The base station receives satellite signals and broadcasts corrections from GPS, GLONASS, GALILEO, BEIDOU, QZSS satellite systems.
The base station is compatible with receivers of any manufacturer, which can receive corrections by RTCM v3 protocol:
- CLAAS
- NovAtel
- Trimble
- Leica
- Topcon
- Java
- South
- Stonex
- Autosteering FJ Dynamics
- Hemisphere
- ComNav
- South
- Emlid
GNSS RTK Base Station is a professional surveying tool with an ideal balance of reliability and cost. The RTK base station transmits the corrections via the local Internet or SIM card.
Fast fixing with low initialization time, the highest degree of reliability and stability make the GNSS base station RTK a universal convenient device for many applications where absolute RTK accuracy is required.
Specifications
-
General
-
Length [m]
0.175
Width [m]
0.34
Height [m]
0.055
System components
Year of introduction
2021
-
GNSS Positioning Sensor
-
Tracked satellite signals
GPS: L1C/A, L2P,L2C; GLONASS: G1, G2; GALILEO: E1, E5b; BEIDOU: B1I, B2I/B3I
No. channels
698
-
Wireless protocols
-
WiFi
Y
Bluetooth
Y
Cellular modem
Y
-
Power
-
Max. external power [Voltage]
220
Operating time with internal power supply [hr]
30
-
Radio modem specifications
-
Maximum distance range of signals [m]
50000
-
Environment
-
Operating temperature: min. [°C]
-40
Operating temperature: max. [°C]
85
Water sand and dust proof
IP67