pay-off

 

Ask for a quote
Visit website Find dealers / rentals

Write a review

SL 600


 
General 
Product Name:SL 600
Description:
System components:No external components are needed. The Satlab SL600 functions as a automatic base station setup from a list of pre-defined coordinates without controller, Base/Rover RTK over internet, Direct Rinex recording, Voice in your local language, Remote internet access to the receiver and Remote logged data downloads.
Year of last update:2016
Year of introduction :
Length [m]:0.182
Width [m]:0.182
Height [m]:0.092
Weight [kg]:1.2
Certifications:
Power 
Typical consumption [W]:
Min. external power [Voltage]:6
Max. external power [Voltage]:28
Internal power supply:Dual battery compartment
Operating time with internal power supply [hr]:15
Environment 
Operating temperature: min. [°C]:-45
Operating temperature: max. [°C]:65
Humidity resistance:Waterproof to 2 m Dept
Water sand and dust proof:IP67
Shock and vibration proof:Shock Resistant Body to 3 m Drop
ROHS compliance:
WEEE compliance:
GNSS Positioning Sensor 
No. channels:220
Max. simultaneous tracked channels:
Tracked satellite signals: 220 Channels. - GPS : L1 C/A, L2E, L2C. - GLONASS : L1 C/A, L1 P, L2 C/A, L2 P. - BEIDOU : B1, B2. - GALILEO : L1 BOC, E5B. - QZSS : L1 C/A, L1 SAIF, L2C. - SBAS : L1 C/A, (WAAS-EGNOS-MSAS-GAGAN).
SBAS differential signals:WAAS-EGNOS-MSAS-GAGAN
Type of measurements:C/A, P-code, full code & carrier data
Update Rate [Hz]:50
Reacqisition time [s]:
Time to first fix after cold start [s]:
Multipath Mitigation:Y
Horizontal correction accuracy 
code: DGNSS/RTC (constant part) [m]:
code: DGNSS/RTC (variable part) [ppm]:
phase: RTK rapid static (constant part) [m]:0.008
phase: RTK rapid static (variable part) [ppm]:1
phase: RTK kinematic (constant part) [m]:
phase: RTK kinematic (variable part) [ppm]:
Radio modem specifications 
Operation frequency range min [KHz]:
Operation frequency range max [KHz]:
Channel spacing [MHz]:
450 MHz transmitter radio power output min. [W]:
450 MHz transmitter radio power output max. [W]:
900 MHz transmitter radio power output min. [W] :
900 MHz transmitter radio power output max. [W]:
Maximum distance range of signals [m]:
Other radio options and protocols:The internal UHF modem is compatible to work with any standardized radio protocol, ensuring your Satlab SL600 will work with any available base or rover station.
Other compatible external radios:
Wireless protocols 
WiFi :N
Bluetooth :Y
Cellular modem:Y
Cellular description [UMTS, CDMA]:3.5G UMTS/HSDPA GSM Modem
Communication: Protocols 
RTCM output protocols:RTCM SC104 2.x, 3.x
CMR output protocols:sCMRx, CMR, CMR+
Other in-/output formats for differential data:sCMRx, CMR, CMR+, RTCM SC104 2.x, 3.x, VRS, FKP, MAC, intRTK Support
NMEA output messages/standards:NMEA Output.
Other output protocols:
Data storage 
Type of data (on board recording):Raw data logging,RINEX Data Logging
Internal memory:1 GB Internal Memory
External memory:Micro SD
Max number of stored known/fixed locations:
More information 
Distinguishable features :Satlab SL600 is built on a LINUX based operating system which controls all hardware and communications for an error free and easy to support solution. Just listen to Satlab SL600, it’s voice prompts will advise you of any issues together with a solution. It always remembers what it has performed before. Once you set up its operating parameters, forget about setting up again. Power up the receiver and its is ready to measure!
 


Ask for a quote
Visit website Find dealers / rentals


Supplier Information
  • SatLab

  • Datavägen 21B
  • 436 32 Askim
  • Sweden

 

 

Other products in RTK Base Stations
All Product Categories